next »

[amigo]

I have a 3 stage heating only application that I like to use 7600 series on but I need the heat setpoint to go as high as 110F, how can I do this?

Thanks.

[Zinc22]

Hey Amigo, long timne no see.

Sadly, you cannot.

The heat setpoint stops at 90F

You could trick it to go higher with a remote sensor & adding restance in series to the thermistor to trick its value, but:
A) It's not clean
B) Resolution & accuracy is crappy at those levels

Also...we do not have a straight 3 heat stage stat.

Sorry   

[amigo]

Thanks, Zinc.
Yes, it has been a while. I hope you guys are doing well.

For this application I was going to use the 7600 in heatpump mode with aux heat.
But if setpoint does not go that high then it won't work in this particular application.

Thanks for the answers.

Amigo